Peak ENP90 test probes

This set of measuring needles is specifically intended for use with the Peak Electronics ESR series. The pins are gold plated and therefore offer high conductivity. They have standard 2 mm connectors. The narrow design is specifically designed for use in hard-to-reach areas.

The needles are very sharp and should be used with care. Except for the 14 mm long tip, they are fully insulated.

Attention, your ESR must have a firmware of at least 4.1 and it should have the 2 mm connectors. This is because firmware update 4.1 has added a "charged capacitor" detection method, which is necessary to cope with the relatively short connection times that can occur when using these pins.

Specifications