This flux from JBC is designed to be used in PCB preparation prior to soldering a PCB component. The flux leaves no residue and can be used for up to 6 months after opening.
How to use
- 1 Clean and degrease the surface.
- 2 Use the brush to apply the flux to the integrated circuit pads
- 3 Solder the joint.
- 4 Flux left behind does not cause any electrical or chemical problems. If there is a residue you want to remove, use water.
Specifications
Solvent | Water (R >106Ω) |
Acid index | 35 mg/ml |
Density 20℃ | 1.003 g/cm3 |
Ionic contamination | <3mg/cm2 |
Standards | F-SW23 / DIN EN29454-1 2.1.3 / DIN EN61190-1-1 of L0 |