This set of measuring needles is specifically intended for use with the Peak Electronics ESR series. The pins are gold plated and therefore offer high conductivity. They have standard 2 mm connectors. The narrow design is specifically designed for use in hard-to-reach areas.
The needles are very sharp and should be used with care. Except for the 14 mm long tip, they are fully insulated.
Attention, your ESR must have a firmware of at least 4.1 and it should have the 2 mm connectors. This is because firmware update 4.1 has added a "charged capacitor" detection method, which is necessary to cope with the relatively short connection times that can occur when using these pins.
Connector | 2 mm |
Point to connector resistance | < 15 mΩ |
Total length | 92 mm |
Contact material | Gold-plated |
Quantity | 2 |